Flat Installation

1.On a relatively flat ground, Place the floor support, As below picture (The spacing between adjacent brackets is 500mm/1000mm)

2.The positioning hole at the bottom of the cabinet body is connected with the positioning column on the surface of the ground support;

The positioning hole of the cabinet body shall be connected and fixed with the four brackets in turn

(The arrow direction on the back of the cabinet body shall be consistent).

3.Connect the power line and signal line on the back of the cabinet with another cabinet in turn (Note: the direction of the cabinet body is consistent).

4.The cabinets are successively connected according to the above contents, As below picture.

5.After the installation of the screen body is completed, It can be decided whether to install the edge to enhance the beauty according to the actual demand.

6.During the use of the screen body should be regularly maintained to ensure the lifetime of the screen.